Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Before & After in Fort Worth, TX
Talk is cheap in this trade. Before-and-after photos show what actually happened when a door that wouldn’t budge became a door that opens smooth and quiet. Below are six jobs our Fort Worth technicians have tackled recently. Every one started with a written price, ended with a 365-day guarantee, and left a door working like it should.
Styles & brands we work with






Recent Transformations
Torsion Spring Replacement in Wedgwood
Before
AfterThis door wouldn’t lift more than six inches. The torsion spring, the thick coiled spring mounted above the door that bears most of the lifting load, had snapped clean in two. Our tech arrived with a replacement rated for the door’s exact weight, swapped both springs so the lift would stay even, and lubed the rollers while he was at it. The door now opens with one hand.
Garage Door Opener Motor Swap in Arlington Heights
Before
AfterThe old Craftsman opener had been grinding for months, and the homeowner was holding the wall button hoping each press would be the last. We pulled the motor head, kept the good rail, and installed a Chamberlain the door actually matched. Quieter operation, working safety sensors, and a remote that doesn’t need to be pointed at the ceiling.
Frayed Cable Replacement in Benbrook
Before
AfterThe cable on one side had all but given up, strands jutting out like a wire brush. That put the whole door off balance, and the remaining cable was doing double duty. We replaced both lift cables, checked the drums for wear, and set the tension so the door travels straight. Total time from driveway pull-up to cleanup: 70 minutes.
Off-Track Door Realignment in the Ryan Place Historic District

An older Wayne Dalton door had jumped its track when a spring lost tension mid-cycle. The door hung at a steep angle, and the homeowner, smartly, didn’t try to force it. We reset the rollers, fixed the track brackets that had bent, and installed fresh springs so the same failure doesn’t happen twice. The door runs true now.
Weather Seal and Panel Alignment in North Richland Hills

You could see daylight under this door from across the garage. The bottom seal was flattened, and two panels had shifted enough to leave a gap on one corner. We squared the panels, replaced the rubber seal, and adjusted the track so the door closes flush against the floor. The garage stays cleaner now, and the air conditioning isn’t fighting the August heat from an open gap.
Full Door Tune-Up and Safety Sensor Repair in Keller

This Genie opener would reverse every time the door got halfway down. The sensors had been knocked out of line, and the door itself was overdue for a tune-up. We realigned the sensors, tightened every bolt on the track, and balanced the springs. The door now closes on the first try, every time.
Want Results Like These?
Every job above started the same way: a phone call, a written price before any work began, and a 365-day guarantee in writing when the job was done. If your door is acting up in Fort Worth, call (682) 730-8314. A real person answers, day or night.
Written by Wade Mercer, Owner at Brock Garage Doors Fort Worth, serving Fort Worth and nearby communities. Wade has been setting the standard for garage door work since 2001, and every job leaves with a written 365-day Done Right Promise behind it.
See the difference
Before
After
Before
After
Before
After