Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterNew Door Installation in Fort Worth, TX
New door installation in Fort Worth typically costs $1,100 to $3,800 depending on door size, material, insulation, and whether you’re upgrading the opener at the same time. Most installations take 3 to 5 hours, and a properly installed steel or composite door will give you 15 to 20 years of service before it needs real attention. At Brock Garage Doors Fort Worth, we put the price in writing before the first bolt comes off the truck, and every installation is covered by our 365-Day Done Right Promise in writing.
We’re not the company that gives you a verbal number over the phone and then “discovers” problems once the old door is on the ground. What we quote is what you pay. That’s part of The Garrison Standard, the way this operation has run since 2001 under the Garrison Partners network. If you’re replacing a door that’s seen better days or building new, call us at (682) 730-8314 and we’ll walk you through what makes sense for your house. You can also see the full scope of what we do on our Garage Door Installation in Fort Worth page.
Key Takeaways:
- Most new door installations in Fort Worth run $1,100 to $3,800, installed
- Steel doors with polyurethane insulation handle Texas heat better than uninsulated aluminum
- You get a written price before work starts and a written 365-day guarantee after
- A live person answers the phone at (682) 730-8314, 24 hours a day
When You Need New Door Installation
Not every door problem calls for a replacement. Sometimes a spring or cable repair gets you another five years. But there are clear signs that a new door is the honest answer. Here’s what we tell homeowners in Fort Worth to look for:
- Structural damage you can’t ignore. A door that’s been hit by a car, a lawn mower, or a teenager learning to park often has bent panels that throw the track alignment off permanently. You can patch a panel, but a bent frame will keep eating rollers and cables.
- Rust and corrosion on load-bearing steel. In Fort Worth’s humidity and occasional hail, steel doors without proper coating can rust at the bottom panels and hinges. Once rust gets into the hinge mounts, repair work becomes a losing game.
- Your door is 20 years old or older. Doors from the early 2000s were often installed with single-panel construction or thin metal that dents easily. Modern insulated doors are quieter, straighter, and dramatically better at keeping garage heat down in August.
- Spring failures on an old door. When a torsion spring, the thick coiled spring mounted above the door that bears most of the lifting load, snaps on a door that’s already sagging, the smart money goes toward replacing the whole system rather than feeding an old door new parts.
- You’re selling or renovating. A new door is one of the highest-return exterior upgrades for curb appeal in Tarrant County. If the old door is faded, dented, or doesn’t match the house, a new installation gets done before the listing photos, not after.
- Noise you can’t stand anymore. Old doors with worn hinges and steel rollers rattle through the whole house. A new door with nylon rollers and proper insulation runs noticeably quieter, which matters when the garage is under a bedroom.
Our New Door Installation Process
Here’s how the job runs from first call to final walkthrough. No surprises, no moving numbers, no mess left behind. That’s the Garrison Code, the checklist our technicians work to on every installation.
- Call and talk to a live person. You call (682) 730-8314. A real human answers, day or night. We ask about your current door, the garage size, and what you’re trying to solve. We schedule a visit that fits your calendar, not ours.
- On-site measurement and assessment. A background-checked, uniformed technician arrives at your home, measures the opening, checks the framing, the headroom, the electrical, and the condition of the track and opener. We look for problems the old door may have hidden.
- Written price before any work starts. You get a line-item quote on paper. Door, hardware, tracks, installation labor, haul-away of the old door, and any opener work. The number on that quote is the number on the invoice. If something changes during the job, you approve it first, in writing.
- Door removal and prep. We take down the old door, springs, and tracks. The mounting points get checked and reinforced if needed. The threshold and weather seal get inspected so the new door seals properly against Texas dust and rain.
- New door installation and calibration. The new door goes in, the torsion springs get wound to the proper tension for your door’s weight, the tracks are aligned, and the opener is adjusted to work with the new door’s balance point. We test the full cycle multiple times.
- Cleanup and a walkthrough. The old door and all packaging leave with us. We sweep the work area, test the door with you, show you the safety reverse function, and hand you the written 365-day Done Right Promise. If it’s not done right, we come back and make it right at no charge.
New Door Installation Pricing in Fort Worth
Here are the ranges we see most often in Fort Worth for new door installation. These are installed prices including the door, hardware, labor, and haul-away. Your specific number depends on the door size, material, insulation level, and whether you replace the opener at the same time.
- Basic single steel door (8×7 or 9×7): $1,100 to $1,900
- Insulated steel door, double layer: $1,600 to $2,600
- Insulated steel door, triple layer (quiet, dent-resistant): $2,200 to $3,200
- 16-foot double door, standard steel: $1,800 to $3,000
- 16-foot double door, insulated, higher gauge: $2,600 to $3,800
- Custom sizes, wood composite, or carriage-house style: $2,800 to $4,500 and up
What moves the price more than anything is the door’s construction. Clopay and Amarr make doors from thin, builder-grade steel all the way up to triple-layer panels with polyurethane insulation that cuts garage temperatures by 15 to 20 degrees in a Fort Worth summer. A Chamberlain or Genie opener adds $300 to $600 installed if you’re replacing it with the door, which we recommend when the old opener is more than 10 years old. The exact quote is free, and it’s in writing before you commit to a dollar of work. Call (682) 730-8314 and we’ll come measure and break it down line by line.
A note on safety: garage door installation involves torsion springs under hundreds of pounds of tension. This is not a weekend DIY project. The tools and techniques for winding torsion springs safely take years to learn, and getting it wrong can cause serious injury. We bring the right equipment, the right training, and a written guarantee. Let a trained professional handle the springs and cables.
FAQs – New Door Installation
How much does new door installation cost in Fort Worth?
New door installation in Fort Worth runs $1,100 to $3,800 for most single and double garage doors, including installation, hardware, and haul-away of the old door. Your exact price depends on door size, material, insulation, and whether you’re replacing the opener. Call (682) 730-8314 for a free written estimate, and we’ll give you the line-item number before any work starts.
How long does new door installation take?
Most new door installations take 3 to 5 hours from arrival to final walkthrough. Double doors, custom sizes, doors with opener replacement, and jobs where the old door damaged the framing can take longer. We’ll give you a clear time window when we schedule, and we show up when we say we will.
Is it cheaper to repair my old door or replace it?
If your door is under 10 years old and the problem is a spring, cable, or roller, repair is usually cheaper and the right call. When the door itself is dented, rusted, or sagging, or when repairs are stacking up on a 15- to 20-year-old door, replacement is usually the better money. We’ll give you an honest assessment either way. If the sensible fix is a repair, that’s what we’ll recommend. Call (682) 730-8314 and we’ll walk through the numbers for your specific door.
Do you remove the old door?
Yes. Haul-away of the old door, tracks, and hardware is included in every new door installation quote. We don’t leave the old door leaning against the fence or stacked by the curb for you to figure out. It leaves with us, same day, and the work area is swept clean before we go.
What brands do you install?
We install doors from Clopay and Amarr, and we set up and calibrate openers from Chamberlain and Genie to work with your new door’s weight and balance. Our technicians are trained on eight major brands total, so the new system works together properly from the first cycle. We’ll recommend the right combination for your budget and garage layout.
Written by Wade Mercer, Owner at Brock Garage Doors Fort Worth, serving Fort Worth.
Call (682) 730-8314 to schedule a free estimate for new door installation. Someone answers, day or night.